ConcreteGauge / Ramp
Concrete ramp calculator
Enter the length and width of the ramp and how thick the concrete is at each end. You get the concrete for the whole wedge.
What to buy
22 cubic feet
0.81 cubic yards, or 0.623 cubic metres. Includes 10% extra for spills and uneven ground. Without it: 20 cubic feet.
Mix it from bags
37 bags of 80 lb
About $240.50. That is 2,960 lb to carry and mix.
Best for this job: under one cubic yard, bags are simpler than a delivery.
Order ready-mix
1 cubic yard
About $150.00 before delivery fees. Rounded up to the next quarter yard, the way suppliers sell it.
| 40 lb bags | 74 |
|---|---|
| 50 lb bags | 59 |
| 60 lb bags | 49 |
| 80 lb bags | 37 |
The concrete weighs about 3,300 lb once poured.
How to measure a ramp
- Measure the length along the ground from the low end to the high end.
- Measure the width.
- The thickness at the low end is how deep the concrete is where the ramp starts.
- The thickness at the high end is the low-end thickness plus the height the ramp climbs. A ramp that starts 4 inches thick and climbs 4 inches is 8 inches thick at the top.
This assumes the ground under the ramp is level and the ramp is solid concrete. If the ramp sits on fill that rises with it, it is really a sloped slab of even thickness: enter the same thickness at both ends.
The formula
Length × width × the average of the two thicknesses, all in feet.
For a ramp 10 feet long and 4 feet wide, 4 inches thick at the low end and 8 inches at the high end:
- Average thickness: (4 + 8) ÷ 2 = 6 inches = 0.5 feet
- 10 × 4 × 0.5 = 20 cubic feet, or 0.74 cubic yards
- Add 10%: 22 cubic feet, or 37 bags of 80 lb
If the same ramp ran down to nothing at the low end it would take 13.33 cubic feet before waste.
How long does a ramp need to be?
The ADA Standards, which apply to public and commercial buildings in the United States, allow a ramp to be no steeper than 1:12. That is 12 inches of length for every inch of height, and no single run may climb more than 30 inches. A private home is not bound by them, but 1:12 is a sound target for a wheelchair, and gentler is easier.
Ramp lengths at 1:12, and the concrete to buy for a solid ramp 4 feet wide that is 4 inches thick at the low end, with 10% extra:
| Height to climb | Length at 1:12 | Cubic feet | Cubic yards | 80 lb bags |
|---|---|---|---|---|
| 3 in | 3 ft | 6.05 | 0.22 | 11 |
| 6 in | 6 ft | 15.40 | 0.57 | 26 |
| 12 in | 12 ft | 44.00 | 1.63 | 74 |
| 18 in | 18 ft | 85.80 | 3.18 | 143 |
| 24 in | 24 ft | 140.80 | 5.21 | 235 |
| 30 in | 30 ft | 209.00 | 7.74 | 349 |
Solid ramps get heavy and costly as they get taller, which is why higher ramps are usually a slab poured over compacted fill or built between side walls.
Short ramps for sheds and garages
A ramp into a shed or over a garage lip is the same wedge, just shorter and often steeper. Measure the height of the lip, decide how long a slope you have room for, and enter them. For a ramp used only by a mower or a barrow the slope is your choice.
Level platforms at the top and bottom are slabs. If you are choosing between a ramp and a few steps, the steps calculator shows what the steps would take.
Questions people ask
How do I calculate concrete for a ramp?
Add the thickness at the low end to the thickness at the high end and halve it. Multiply that average by the length and the width, all in feet, to get cubic feet. Divide by 27 for cubic yards.
How much concrete do I need for a 10 foot ramp?
A ramp 10 feet long and 4 feet wide, 4 inches thick at the bottom and 8 inches at the top, takes 20 cubic feet. With 10% extra that is 22 cubic feet, or 37 bags of 80 lb.
How long should a ramp be for a 12 inch rise?
At the 1:12 slope in the ADA Standards, 12 feet. A solid ramp that size, 4 feet wide and 4 inches thick at the low end, takes 1.63 cubic yards including 10% extra.
What is a 1:12 slope?
One unit up for every twelve units along: 1 inch of height for each foot of ramp. It is the steepest slope the ADA Standards allow for a new ramp.
Can the low end be zero?
In the calculator, yes: enter 0 and the ramp is worked out as a full wedge. Check with your concrete supplier or builder how thin the edge can really be poured for your mix and use.
Where the numbers come from
- Ramp slope and rise limits: 2010 ADA Standards, sections 405.2 and 405.6, explained in the U.S. Access Board guide to ramps.
- Bag yields: a 40 lb bag makes about 0.3 cubic feet, 50 lb about 0.375, 60 lb about 0.45 and 80 lb about 0.6 (ArcSite, Concrete Network). Brands differ a little, so check the yield printed on your bag.
- Bag yields outside the United States: in the United Kingdom and Ireland a 20 kg bag makes about 0.01 cubic metres (Blue Circle, at Travis Perkins); in Australia and New Zealand 108 bags of 20 kg make a cubic metre (Boral); in Canada a 30 kg bag makes about 0.44 cubic feet (Quikrete, at Home Depot Canada). The 25 kg figures are worked out in proportion.
- Weight: 150 lb per cubic foot for normal concrete (Omni Calculator).
Every formula on this page is checked by an automatic test each time the site is updated. Last reviewed 15 November 2026.