ConcreteGauge

ConcreteGauge / Gravel base

Gravel base calculator for concrete slabs

Enter the size of the slab and how deep the gravel base will be. You get the tons and the cubic yards to order.

Measured after it is compacted.

About 105 for crushed stone. Your supplier can tell you theirs.

More options: extra for waste

Gravel to order

7.7 US tons

5.43 cubic yards, 146.7 cubic feet or 4.15 cubic metres. Includes 10% extra for compaction and uneven ground.

Quarries sell by the ton and landscape yards by the cubic yard, so both are shown. A layer 4 inches deep over 400 square feet.

Concrete4 in20 ftGravel base

The formula

Length × width × depth in feet = cubic feet. ÷ 27 = cubic yards. × 105 ÷ 2,000 = tons.

For a 20 × 20 foot slab on a 4 inch base: 20 × 20 × 0.333 = 133.33 cubic feet. With 10% extra that is 146.67 cubic feet, 5.43 cubic yards, or 7.7 tons.

Gravel for common slabs

With 10% extra, at 105 lb per cubic foot.

Slab4 inch base6 inch base
Cubic yardsTonsCubic yardsTons
10 × 10 ft1.36 yd1.9 tons2.04 yd2.9 tons
12 × 12 ft1.96 yd2.8 tons2.93 yd4.2 tons
12 × 16 ft2.61 yd3.7 tons3.91 yd5.5 tons
16 × 20 ft4.35 yd6.2 tons6.52 yd9.2 tons
20 × 20 ft5.43 yd7.7 tons8.15 yd11.6 tons
24 × 24 ft7.82 yd11.1 tons11.73 yd16.6 tons
24 × 30 ft9.78 yd13.9 tons14.67 yd20.8 tons
30 × 40 ft16.30 yd23.1 tons24.44 yd34.7 tons

Tons or yards?

Quarries weigh the truck and sell by the ton. Landscape suppliers fill a loader bucket and sell by the cubic yard. A cubic yard of crushed stone weighs roughly 2,700 to 2,800 lb, about 1.35 to 1.4 tons, and material with fine dust in it, sold as crusher run or road base, can reach 1.5 tons. If your supplier quotes a weight per yard, turn it into pounds per cubic foot by dividing by 27, and enter it above.

How deep should the base be?

For house floors, the International Residential Code calls for a base course of 4 inches of clean graded sand, gravel or crushed stone under the slab, unless the ground itself is already well-drained sand or gravel. Outdoor slabs are not covered by that rule, and 4 inches is the common choice for them too, with more on soft or wet ground.

The depth you enter is the finished, compacted depth. Loose gravel settles when it is compacted, so the 10% extra is doing real work here; on a large job ask the supplier how much their material compacts and raise the figure to match.

What goes on top

Indoors, a plastic sheet goes between the gravel and the concrete: the vapor barrier calculator counts the rolls. Then the forms are checked, steel or mesh is placed, and the slab calculator gives the concrete.

Questions people ask

How much gravel do I need under a concrete slab?

For a 4 inch base, about 1.9 tons for every 100 square feet, including 10% extra. A 20 × 20 foot slab needs 7.7 tons, or 5.43 yd.

How many tons of gravel are in a cubic yard?

About 1.4 for crushed stone, a little more for material with fines in it. Ask your supplier for the figure for theirs.

How thick should the gravel be under concrete?

Four inches is the base course the International Residential Code asks for under house floors, and the usual choice outdoors. Soft or wet ground may need more.

Do I need gravel under a concrete slab?

On most ground, yes: it gives an even, drained bed that does not hold water against the slab. The residential code allows it to be left out only where the soil is already well-drained sand or gravel.

How much extra gravel should I order?

The calculator adds 10%. Gravel compacts and the ground is never perfectly level, so a little over is normal and a shortfall means a second delivery charge.

Where the numbers come from

  • In metric countries the same weight is shown as 1,680 kg per cubic metre (105 lb per cubic foot, converted), and the answer in tonnes.
  • Weight of crushed stone per cubic yard: Select Sand & Gravel, How Much Does a Yard of Crushed Stone Weigh?
  • Base course under floor slabs: International Residential Code R506, as set out in this City of Minneapolis handout.
  • Bag yields: a 40 lb bag makes about 0.3 cubic feet, 50 lb about 0.375, 60 lb about 0.45 and 80 lb about 0.6 (ArcSite, Concrete Network). Brands differ a little, so check the yield printed on your bag.
  • Bag yields outside the United States: in the United Kingdom and Ireland a 20 kg bag makes about 0.01 cubic metres (Blue Circle, at Travis Perkins); in Australia and New Zealand 108 bags of 20 kg make a cubic metre (Boral); in Canada a 30 kg bag makes about 0.44 cubic feet (Quikrete, at Home Depot Canada). The 25 kg figures are worked out in proportion.
  • Weight: 150 lb per cubic foot for normal concrete (Omni Calculator).

Every formula on this page is checked by an automatic test each time the site is updated. Last reviewed 15 November 2026.

What you may need next